What should Be Paid Attention to When Maintaining the Rowing Welding Machine

Sep. 11, 2020
Share:

The operator of the welding machine is not allowed to approach the upper electrode being pressurized or put it between the upper and lower electrodes.

The operator of the welding machine shall not allow any part of his/her body or any object to approach the gear, drive trough, sprocket, belt, chain, straightening machine, induction body, proximity switch, and conductor with dangerous voltage in the electric cabinet or transformer.

The operator of the welding machine must not disassemble or break the zero (grounding) safety protection wire on the host and the electric control cabinet, and regularly check whether the zero (grounding) safety protection wire is good.

The operator of the welding machine shall not plugin or touch the power adjustment plug on the power transformer of the welded mesh power supply transformer, and shall not lift the protective plate.

The operator of the welding machine is not allowed to adjust the components in the electric control cabinet at will and is not allowed to put tools, iron wires, and other sundries into the electric control cabinet or put it on the top of the cabinet or on the rack.

Wire Mesh Welding Machine

When there is a fuse in the electrical control cabinet of the row welding machine, stop and power off first. After the electrician finds out the cause of the fuse, replace it with a fuse of the same model and specification, otherwise, it will cause fire and burn the device.

The operator of the welding machine should pay attention to see, hear, and smell at any time, and discover the signs of accidents and hidden equipment hazards in advance. When abnormal phenomena are found, they should immediately shut down and power off for inspection and treatment.

The operator of the welding machine should timely add lubricant to the rolling friction parts such as bearings, sliders, slides, sliding sleeves, sprockets, chains, gears, racks, etc., and run without oil. A lubricating oil should be added after shutdown. In the part where lubricating oil is added during operation, the lubricating device must not touch the operating mechanism, and the drip injection method may be used.

After a period of use, the upper and lower electrodes of the row welding machine will have different degrees of wear or electrical corrosion. The degree of wear varies with the material and wire diameter. When it is more serious, it will directly affect the quality of the solder joints. , Resulting in false welding or missing welding, users should pay attention to timely maintenance and adjustment. When the upper and lower electrodes cannot be recovered after long-term use, they need to be replaced (the material is chromium zirconium copper).

The operator of the row welding machine shall not switch on the welding power supply to start operating without the warp and weft wire. Otherwise, a large short-circuit current will flow between the upper and lower electrodes, which may cause damage to the upper and lower electrodes or the electronic control system.

When the welding machine operator leaves the mesh welding machine for some reason, shut down and cut off the power, and adjust the speed control knob to the minimum. When leaving for a long time, turn off the speed control power switch and the main power switch, lock the electric control cabinet to avoid misoperation by others, and keep the upper and lower electrodes out of contact, and do not stay in pressurized contact.

The information is provided by the mesh wire machine manufacturer.